Checking the suction power, suction hose diameter and suction hose

  • Suction power

    Ensure that the suction power is not set too low. Press the + button to set a higher suction power.

    +

  • Suction hose diameter

    If your suction hose does not have an RFID chip, as shown here, for identifying the suction hose, then you must set the suction hose diameter manually in standby mode. You can do this by pressing the + and - buttons on the touch panel

    +

  • Suction hose

    The acoustic warning signal could also have been triggered by a kinked or clogged suction hose. Check the suction hose.

    +

Checking the main filter

  • Cleaning the main filter manually

    Switch on the mobile dust extractor and set maximum suction power. Block off the suction hose while briefly pressing the cleaning lever down three times.

    +

  • Checking the main filter

    Pull the filter drawer out and vacuum it using a different mobile dust extractor.

    +

  • Changing the main filter

    To avoid damaging the suction turbine, replace the main filter if damaged.

    +

Checking the filter bag

  • Checking the filter bag

    Change the filter bag if full.

    +

  • Cleaning the filter bag manually

    Switch on the mobile dust extractor and set maximum suction power. Block off the suction hose while briefly pressing the cleaning lever down three times.

    +
Any further questions?

Whether you require advice, support or repair – we are always happy to hear from you.

Use the "SERVICE" menu in the Work App.